Maintenance of your Magic Mitre
Video Demonstration
Maintaining Your Rotating Guide Posts
Cleaning and maintaining the Magic Mitre
It is essential that you check each time before you use your Magic Mitre to ensure that both locking screws are firmly locked in position. You must also clean under the locking screws and remove all dust and waste material with the aid of a dry brush on a regular basis.
To ensure the saw guide moves freely within its track it should also be removed and cleaned regularly with a dry brush.
The posts that guide the Saw are designed to wear and can be rotated by bringing in a new wearing edge. Simply undo the eight screws, with the aid of a suitable screwdriver (not provided), and whilst ensuring you do not break the various components, carefully take the Saw Guide assembly apart. Then turn each post 45 degrees and reassemble.
When reassembling the Saw Guide Assembly, the long guide slot in the top of the Saw Guide should be directly over the long guide slot in the bottom component. This way the pivot points will be directly aligned to accommodate the workpiece holders.
Always ensure the eight screws are fully tightened afterwards.
Regular maintenance of your Magic Mitre will increase it's performance.
Please Note
These TOP TIPS for cutting Mitre joints are provided as a service from MML (QS) Ltd. The information is intended to help with the cutting and fitting of mouldings around the house with the use of the "Magic Mitre" product.
MML (QS) Ltd assumes no liability for omissions, errors or the outcome of any project. The reader and user of the product must always exercise all reasonable caution and follow all applicable codes and regulations and the safety instruction.